
Water Heater Replacement Cost and What Moves It in Boise
Pricing a new water heater in Boise? See typical ranges by size, what the permit adds and what to ask for, then call or text for your number.
Updated Prices checked
- Ranges by tank size, laid out
- Permit and extras itemized
- Price before any work starts
Water heater trouble?
The range is wide because "a water heater" covers a 40-gallon electric in a closet and a 75-gallon gas unit with a new flue. The house decides where in the range you land, and so do the choices below.
$1,000–$3,400
Replacement tank water heater, installed (national average)
Switching to tankless is a different job with its own bill; the tankless cost guide covers it.
What does each tank size cost?
Bigger tanks cost more to buy, and the capacity you need depends on how many people share the hot water.
| Capacity | Typical installed range | Households it suits |
|---|---|---|
| 40 gallons | $700–$2,650 | one or two people |
| 50 gallons | $750–$2,800 | two to four people |
| 75 gallons | $1,100–$3,800 | five or more, or heavy use |
The sizing bands come from Rheem's guidance, and the gas vs electric and sizing guide walks through them. Gas and electric tanks sit in similar ranges, though venting or a new circuit can tip one above the other.
What does the Boise permit cost?
Replacing a water heater needs a plumbing permit from the City of Boise, and the fee is small next to the job. The City's Plumbing Code Fee Schedule dated October 2026 lists a $33 base permit fee plus $12.50 for each water heater. By our arithmetic that is $45.50, which this guide rounds to about $46.
A gas heater can also draw a separate Mechanical permit for the gas piping, and the City's guide treats that as its own application. Fees change each October, so the permit guide is the place to see the current steps. Work done without a permit can draw a special investigation fee equal to the permit fee.
What else changes the price here?
A handful of local requirements decide whether a quote is complete. The City's June 2025 Water Heater Installation Guide is what the inspector uses.
- Expansion tank: required when the plumbing is a closed system, meaning a check valve or pressure-reducing valve sits on the cold side. Installed, one typically costs $225 to $625.
- Drain pan: required on any floor other than concrete, with a metal or listed pan under a gas heater. A heater in an upstairs closet or over a finished floor needs one.
- Relief valve and discharge line: full size, pointing down, never plugged or threaded.
- Access: the City's Water Heater Access Policy says a heater must sit where it can be serviced or replaced without moving a furnace, washer or dryer, or doing permanent construction. A cramped closet can mean relocating the tank.
- Gas piping: gas line size is re-checked when a bigger BTU load goes in, such as a larger tank.
- Altitude: gas heaters are built for sea level to 2,000 feet unless the label says otherwise, and Boise sits at about 2,700 feet. Ask whether the unit you are quoted suits the elevation.
Want every line item priced for your house? Call or text for a quote.
What should a good quote spell out?
A good quote lists the model, the labor, the permit and the old-tank removal as separate lines, so two bids can be compared like for like.
- Make, model, tank size and warranty length.
- Labor, either one flat price or hours at a named rate.
- The City of Boise plumbing permit, and who pulls it.
- Expansion tank, drain pan and discharge line to the City's guide.
- Removal and disposal of the old tank.
- Venting, gas connector or wiring changes the house needs.
Ask for the contractor's Idaho license and look it up on Idaho Division of Occupational and Professional Licenses (DOPL)'s public license search. Financing is commonly offered on bigger jobs; ask for the terms in writing.
Should I repair or replace?
Repair when the tank is young and the fault is one inexpensive part. Replace when the tank is past about a decade, leaks through the shell or needs a second repair in the same year. Tanks typically last 8 to 15 years, and the lifespan guide lists the warning signs.
Hardness varies across Veolia's system, from 13 to 219 mg/L in its 2025 report, so a replacement in a hard-water pocket of town may pay off sooner than a repair on a heater already coated in scale.
Who can do the work in Idaho?
Under Idaho statute the tank and the vent dedicated to it fall under plumbing. A licensed plumber does it, though a homeowner may do plumbing in a home they own or are buying, with the City permit and code still applying. The gas piping can also be done by an HVAC-licensed contractor.
These ranges are rounded from national cost guides, not Boise quotes; the pricing page explains the method. Get your quote for a figure that fits your house.
Ready to compare real numbers for your water heater? Call or text any hour.
Questions homeowners ask
How much does it cost to replace a water heater in Boise?
National cost guides put a standard tank water heater installed at about $1,000 to $3,400, and a 50-gallon tank between $750 and $2,800. The Boise permit, code parts and access then move your own total.
How much is the City of Boise permit for a water heater?
Under the City's October 2026 plumbing fee schedule, a base permit fee of $33 plus $12.50 for the water heater comes to $45.50 by our arithmetic. Fees reset each October, so confirm the figure with the City's Building Division.
Why are two quotes so far apart?
Quotes usually differ in the tank itself, the warranty and what is included, such as the permit, expansion tank, drain pan and haul-away. Ask for each item as its own line before comparing totals.
How many hours does a swap take?
Plan on roughly 1 to 3 hours for a tank swapped for a tank. Moving the heater or changing the fuel stretches it.
Is it cheaper to repair or replace my water heater?
Nationally, a repair visit typically runs $200 to $850 and makes sense for one inexpensive part on a young tank. A tank near the end of its typical 8-to-15-year life, or one leaking through the shell, is better replaced.
Last updated: