
Water Heater Repair & Replacement in Depot Bench, Boise
Water heater in the garage gone cold, or the pilot keeps dying? Depot Bench homeowners can call or text any hour and get a call right back.
- Depot Bench homes, ZIP 83705
- Garage tanks and gas safety
- Price before any work starts
Water heater trouble?
- ZIP
- 83705
- Where
- Boise's bench country
- Homes
- 76% single-unit
- Size
- 6,530 people, 3,251 homes (2019 estimate)
Depot Bench is part of Boise's bench country, in ZIP 83705, with 6,530 people and 3,251 homes in the City's 2020 almanac. About 76% of those homes are single-unit houses, and wherever yours sits, whether a garage, a closet or a utility room, the location decides which rules apply.
Smell gas, or the pilot won't stay lit?
A rotten-egg smell or a hissing sound near a gas line comes first, and it's an emergency. Leave the house without switching lights on or using a phone inside, then from outside call 911 and Intermountain Gas's 24-hour line at 800-548-3679.
If it's only the pilot, the usual suspects are a worn thermocouple, a dirty pilot assembly or a failing gas control valve. A thermocouple repair typically costs about $125 to $250, and a pilot or igniter about $50 to $175. A gas control valve is a bigger job, typically about $250 to $450. See water heater repair for how those compare with a replacement.
What matters about a garage installation?
A water heater in a garage is an ignition source, so the rules put it up off the floor. The City of Boise's installation guide spells out the heights:
- Gas heaters: the burner and ignitor at least 18 inches above the garage floor.
- Electric heaters: the lowest element at least 18 inches up.
- Electric wiring: run in conduit.
State code agrees: Idaho keeps a rule that garage ignition sources be at least 18 inches above the floor. If your tank sits on the garage slab at ground level, ask whether it's raised on a stand.
Tank in a Depot Bench garage? Call or text and get a price first.
Pans, flex lines and the details an inspector checks
Replacing a heater brings the work up to the current checklist, so know what to expect on the invoice:
- Drain pan. Required unless the floor is concrete; a garage slab usually is, a finished utility room might not be.
- New gas flex connector. Never reused, and no longer than 24 inches.
- Gas shut-off within 6 feet of the heater, and a dip leg ahead of the valve.
- Carbon monoxide alarm outside sleeping areas when there are fuel-fired appliances or an attached garage.
None of this is exotic, but a skipped step can hold up the inspection. The permits guide for Boise goes through each item.
Who is allowed to connect the gas?
Under Idaho law, a plumber with a current license may do the gas connection to a heater, and so may an HVAC-licensed contractor for gas piping. An HVAC or electrical license also covers the electrical connection when the disconnect is in sight and the circuit is no more than 50 feet.
You may do plumbing in a single-family home you own, but the City permit and code apply to you too. Gas piping between meter and appliance is a separate mechanical permit. To check someone's license, use the State Plumbing Board's public search.
Questions homeowners ask
How high must a gas water heater sit above the garage floor in Boise?
The City of Boise's installation guide says the burner and ignitor must be at least 18 inches above a garage floor. An electric heater's lowest element has to be 18 inches up as well.
Do I need a drain pan under my water heater?
Boise requires one on any floor other than concrete, with at least 1 inch of clearance all round, piped to a drain, a garage floor or outside. For gas heaters the pan must be metal or listed.
What is a flex gas connector, and can I reuse the old one?
It's the flexible tube joining the gas valve to the supply line. The City's guide requires a new one at each installation and caps its length at 24 inches, so the old one doesn't get reused.
Who can connect the gas line to a water heater in Idaho?
A licensed plumber, or an HVAC-licensed contractor for gas piping. Idaho law lets you do plumbing in a home you own, but the City permit and code still apply.
Last updated: